SKY外语计算机学习

标题: 装配夹具的定位误差对关门力的影响 [打印本页]

作者: lorry    时间: 2013-10-14 22:44
标题: 装配夹具的定位误差对关门力的影响
本帖最后由 lorry 于 2013-10-15 08:47 编辑

作者:Lorry 日期:2013-10-14   原文地址: http://www.skywj.com/thread-9196-1-1.html

Theoretic Analysis of Factor to Affect DoorClosing Force by Positioning Error of Assembly Fixture
装配夹具的定位误差对关门力的影响

ABSTRACT
摘要
In order to analyze positioning errors of assembly fixture of car SANTANA 2000, a 3D CAD model of fixture is built in this paper. Six typical deviation models are defined on the basis of six points positioning principle for fixture. The assembly gap distribution between door and side frame is analyzed and the influence of different deviation patterns on assembly gap is studied, and the effect of assembly gaps on door closing force is evaluated meanwhile.
The results show that positioning errors of door assembly fixture is one of the most important factors to affect the door closing force.
为了分析桑塔纳2000装配夹具的定位误差,本文建立了一套夹具的三维模型。 依据六点定位原则定义了六个典型的误差形式。我们首先分析了车门和门框的装配间隙分布情况,其次研究了不同偏差形式对装配间隙的影响,同时也评估了装配间隙对关门力的影响程度。分析结果显示,装配夹具定位误差是影响关门力因素中最重要的因素之一。

作者: Kill    时间: 2013-10-15 16:13
这种文章虽然偏技术一些,但是仅从摘要看,用语还是比较通俗的,很不错,以后可以多引入这种翻译文章!




欢迎光临 SKY外语计算机学习 (http://skywj.com/) Powered by Discuz! X2.5